Skip to content
Frequency Generator

432 Hz vs 440 Hz Tuning: The Facts, Not the Myths

If you have seen music labeled “432 Hz version”, you have probably also seen the claim that it sounds warmer, more natural or better for you than the 440 Hz that almost all modern music uses. The numbers refer to something real and fairly ordinary: the pitch that the note A above middle C is tuned to.

This page sticks to what can be checked. Where 440 Hz came from, how big the gap between 432 Hz vs 440 Hz actually is, how to hear it for yourself, and why the bigger claims do not hold up.

Try Frequency Generator

Tone generation, sound tests, and musical tuning in one app.

What the number actually sets

A tuning reference fixes one note, and every other note follows from it. With A4 at 440 Hz, the A an octave above is 880 Hz and the one below is 220 Hz. In equal temperament, the tuning system nearly all modern instruments use, each semitone is a step of the twelfth root of two, about 5.95%. Middle C works out to 261.63 Hz.

Move A4 to 432 Hz and every note moves down by the same proportion. Middle C becomes 256.87 Hz, E5 becomes 647.27 Hz, and so on. Nothing about the relationships between notes changes. A chord is the same chord, just slightly lower.

How big is the difference between 432 Hz and 440 Hz?

Musicians measure pitch differences in cents: 100 cents to a semitone, 1,200 to an octave. The gap here is 1200 × log2(440 ÷ 432), which comes to about 31.8 cents, just under a third of a semitone.

That is clearly audible when the two are played one after the other, and obvious when they are played together, because two tones 8 Hz apart produce a fast wobble, eight beats per second. It is much harder to notice in isolation. Unless you have absolute pitch, you cannot listen to a song and say which reference it uses, because most people hear pitch relative to the rest of the music rather than against an internal standard.

It also helps to know that plenty of recorded music is not at exactly 440 Hz anyway. Older recordings drift with tape speed, bands tune to whatever piano or reference is in the room, and producers sometimes shift a whole track to suit a singer.

Where the 440 Hz standard came from

For most of history there was no standard. The pitch of A varied by country, by city and sometimes by individual organ. Surviving instruments and tuning forks show values spread across more than a semitone, some well below 420 Hz and others above 450 Hz. A musician traveling between cities could find the same piece sitting noticeably higher or lower.

Attempts to fix a single pitch came in the nineteenth century. In 1859 France set an official pitch of A = 435 Hz, which was taken up in other countries too. In 1939 an international conference in London agreed on 440 Hz, and the International Organization for Standardization adopted it in 1955, reaffirming it in 1975 as ISO 16.

440 Hz was a practical choice close to what many orchestras and instrument makers were already using. 432 Hz was one of many values found in history; it was never a lost original that 440 replaced. Stories that 440 Hz was imposed for sinister reasons have no documentary support.

Today, 440 Hz is the reference for most tuners, instruments and recorded music. Many orchestras tune slightly higher, often 441 to 443 Hz, especially in continental Europe, and ensembles playing Baroque music on period instruments commonly use 415 Hz by convention.

Hearing the difference yourself

You do not need to take anyone’s word for how the two compare. Keep the volume low throughout; sustained tones get tiring quickly, and there is nothing to gain from loud.

  1. Start with bare tones. Play 440 Hz, then 432 Hz. Then play both at once and listen to the beating. In Frequency Generator you can set the A4 reference to either value in the musical notes mode, or put both tones on the multi-oscillator and play them together.
  2. Move on to music. A single tone tells you nothing about how a piece of music feels. Take a short recording and make a copy pitch-shifted down by 32 cents. Most audio editors can do this without changing the tempo.
  3. Match the loudness. Make sure both versions play at the same level. When two otherwise identical clips differ in volume, the louder one usually sounds better.
  4. Do it blind. Have someone play the two versions in random order, and write down which you prefer before you are told which was which. Repeat several times.

Most people find the difference subtle and their preference inconsistent. If you do have a reliable preference, it is real for you. It just is not evidence about the number.

The note frequency chart lists every note at A4 = 440 Hz or 432 Hz, or any reference from 430 to 450 Hz, and the online tone generator plays any of them in your browser.

Why the 432 Hz claims don’t hold up

“432 Hz is mathematically natural.” A frequency in hertz counts cycles per second, and the second is a human unit of time. Count cycles per minute, or per any other unit, and the “special” number stops being special. Nothing in physics singles out 432.

“It matches C = 256 Hz.” Some arguments link 432 Hz to a middle C of 256 Hz, a power of two. In equal temperament, A4 = 432 Hz gives a middle C of 256.87 Hz, not 256. The tidy link only works in Pythagorean tuning, where A sits at exactly 27/16 of C. Going the other way, C = 256 Hz in equal temperament gives an A of about 430.54 Hz.

“Every note becomes a clean number.” In equal temperament only the reference note and its octaves are round numbers. With A at 432 Hz, most notes have long decimal frequencies, exactly as they do at 440 Hz.

“It is better for you.” No credible evidence links a tuning reference to any health effect. A handful of small studies have compared listeners’ responses to the same music at the two tunings; they are small, often not blinded, and do not establish any health benefit. For more on where claims like this come from, see 432 Hz, 528 Hz and healing frequencies.

“Famous musicians used it.” Historical pitch varied so widely that you can find a precedent for almost any reference near today’s. A precedent is not a reason.

When 432 Hz is a perfectly good choice

None of this makes 432 Hz wrong. If you play alone, or with people who agree on it, you can tune to whatever reference you like. The instrument does not care. A few practical points:

  • Playing along with recordings at 440 Hz will leave you about 32 cents flat.
  • String tension drops slightly. Tension rises with the square of frequency, so tuning a guitar to 432 Hz lowers it by about 3.6%. Strings feel a touch slacker.
  • Fixed-pitch instruments such as pianos are tuned by a technician to one reference, so changing it is a job, not a setting.
  • Many electronic tuners let you change the A4 reference, often in 1 Hz steps.

Frequency Generator’s musical notes mode lets you set the A4 reference anywhere from 430 to 450 Hz, which covers 432 Hz, the 440 Hz standard and the 442 Hz many orchestras use. For a step-by-step guide to tuning by ear against those notes, see how to tune a guitar with reference tones.

Get occasional updates

New features, tips, and the occasional announcement. No spam.

More from us