DTMF Tone Generator
The touch-tone sounds of a phone keypad — every key, including *, # and A–D. Press and hold a key, or type a number and dial it with exact timing.
Press a key
Press and hold. Your keyboard works too: 0–9, *, # and A–D.
Digits, *, # and A–D. A comma adds a one-second pause; spaces and dashes are ignored.
Only dial real numbers into systems you are allowed to use. Tones played into a phone's microphone are usually, but not always, recognized.

A keypad in your pocket
Frequency Generator has a DTMF keypad and an SFX generator alongside its tone, sweep and noise tools — no browser tab needed. Free to download.
The DTMF frequency table
Each key is the sum of its row tone and its column tone:
| 1209 Hz | 1336 Hz | 1477 Hz | 1633 Hz | |
|---|---|---|---|---|
| 697 Hz | 1 | 2 | 3 | A |
| 770 Hz | 4 | 5 | 6 | B |
| 852 Hz | 7 | 8 | 9 | C |
| 941 Hz | * | 0 | # | D |
Why two tones per key
A single tone is easy to fake by accident — a whistle or a sung note can hit it. Two tones from two separate groups, sounding at once, almost never occur in speech or music. That is what lets a phone exchange or a menu system pick digits out of a live voice line reliably. The frequencies were also chosen so that none is a simple harmonic of another, which keeps decoders from confusing one key for another.
What people use DTMF tones for
- Phone menus — “press 1 for sales” systems listen for these exact pairs.
- Radio — amateur radio repeaters and remote equipment are often controlled with DTMF sequences.
- Testing — checking a decoder, an intercom or a recording chain against known tones.
- Sound design — the sound of a phone being dialed, generated cleanly rather than recorded.
Guides
Questions
What does DTMF stand for?
Dual-tone multi-frequency. Every key on a phone keypad is two sine tones played together: one from a low group (697, 770, 852 or 941 Hz) for its row, and one from a high group (1209, 1336, 1477 or 1633 Hz) for its column. The 5 key, for example, is 770 Hz plus 1336 Hz.
What are the A, B, C and D keys?
The fourth column of the full DTMF keypad, at 1633 Hz. Ordinary phones never had them, but the tones are part of the standard and are still used by some radio, signaling and control systems. They are included here for completeness.
How long should a DTMF tone be?
Decoders typically need a tone of at least about 40 milliseconds with a similar gap, and most phones send around 70–120 ms. The defaults here — 120 ms on, 100 ms off — are comfortably inside what real systems accept. If a menu system misses digits, lengthen both.
Can I use this to navigate a phone menu?
Often, yes: hold your phone's microphone near the speaker playing the tones. It is not guaranteed — some calls compress audio or detect DTMF separately from the voice signal — but it works more often than not.