Skip to content
Frequency Generator

Bass & Subwoofer Test

Low test tones from 10 Hz to 200 Hz and a slow bass sweep. Find where your subwoofer, car audio or headphones really stop — and whether what you hear is bass or distortion.

Tap a frequency

— Hz

Hz · tap again to stop

Sweep speed

Set the volume with the 100 Hz tone, then leave it. Deep tones at high level can damage a speaker — stop at any knocking or flapping sound. Phone and laptop speakers produce almost nothing in this range.

Test from the driver's seat

Frequency Generator's Bass/Subwoofer Test keeps playing with the phone locked, so you can sit in the car or walk around the room while it runs. It also has a sweep generator and a tone generator down to 1 Hz. Free to download.

The three bands of bass

  • Sub-bass, 20–60 Hz. Felt as much as heard: cinema rumble, organ pedals, the bottom of an 808. Needs a subwoofer or a large driver.
  • Bass, 60–120 Hz. Kick drums and bass guitar fundamentals — what most people mean by bass.
  • Upper bass, 120–250 Hz. Warmth and body. Small speakers live or die here.

Below 20 Hz is infrasound. The 10 and 15 Hz buttons are there for large subwoofers and car systems; on most equipment they produce nothing audible at all, and that is the correct result.

How to read the result

Keep the volume fixed and step down from 100 Hz. The first frequency where the tone gets clearly quieter is your usable limit; the one where it disappears is where the speaker stops. A decent bookshelf pair typically fades somewhere around 50–70 Hz. A good subwoofer should still be strong at 30 Hz.

The trap: distortion that sounds like bass

A speaker asked for a frequency it cannot produce does not go silent. It produces harmonics — multiples of the tone. Ask a small speaker for 30 Hz and you may hear 60 Hz and 90 Hz instead, and conclude it reaches 30 Hz. A real low tone sounds smooth and featureless, like a hum. If it sounds buzzy or has a clear, higher pitch, you are hearing the speaker fail, not bass.

Car audio

Test with the engine off and every processing option — loudness, bass boost, surround — switched off. Then step through the tones and listen for rattles: a buzzing door card or number plate at one frequency is a loose part, not a failing subwoofer. The subwoofer guide covers crossover and phase setup step by step.

Guides

Questions

What Hz is best to test a subwoofer?

Run the whole ladder rather than one tone. Start at 100 Hz to set a comfortable level, then step down: 80, 60, 50, 40, 30 and 20 Hz. A good subwoofer is still clearly present at 30 Hz and you should feel 20–25 Hz more than hear it. The frequency where the output drops sharply is the real lower limit, whatever the box says.

Why can't I hear the lowest tones on my phone?

Phone and laptop speakers are a few millimeters across and cannot move enough air to produce deep bass — most give out somewhere in the low hundreds of hertz. If you hear anything at 40 Hz on a phone, it is distortion at higher frequencies, not the tone itself. Use headphones, a car system or a proper speaker.

Why does the bass sound different in different parts of the room?

Standing waves. Low frequencies have wavelengths of several meters, and they reflect off walls into peaks and nulls. One seat can have a boom at 50 Hz while another, a meter away, has almost none. Play a single tone and walk around — then move the subwoofer, not just your chair.

Can test tones damage a subwoofer?

Yes, if they are loud and long. A sustained deep tone works a driver harder than music does. Keep tones short, keep the level moderate, and stop immediately at any knocking, flapping or mechanical noise — that is the cone hitting its limit.

Is this the same as a speaker test?

This page is for the low end only. To check left and right channels and stereo balance, use a speaker test; to sweep the whole range, use the frequency sweep generator.

More free tools

Get occasional updates

New features, tips, and the occasional announcement. No spam.

More from us