Frequency Sweep Generator
Sweep a test tone between any two frequencies, from 1 Hz to 22 kHz, over the time you choose. Logarithmic or linear, once or on repeat — all generated live in your browser.
Now playing
Set a low volume first and leave it there. Never run a full-range sweep loudly on headphones — the top end arrives quietly and then is suddenly too much.
Presets

Sweeps that keep running
Frequency Generator's sweep generator loops and repeats with the screen off — handy when you are under a car dashboard or across the room from the speaker. It keeps up to 15 sweeps ready for free; PRO adds more and exports them as WAV files.
What a frequency sweep shows you
A sweep plays every frequency between two points in one smooth glide. It is the quickest way to hear a whole system at once: where the bass fades out, where the treble disappears, and — most usefully — where something goes wrong. A rattling door panel, a cracked cone or a room resonance announces itself as a buzz or a sudden swell at one point of the sweep.
Choosing the range
- 20 Hz → 20 kHz covers the whole audible range. Use it first, at a low volume, to get an overview.
- 200 → 20 Hz walks down into the bass, where speakers and rooms differ most. Listen for the point where the tone thins out — that is your real low-end limit. The bass test has fixed tones for checking each step.
- 2 kHz → 20 kHz checks the tweeters and the top of your headphones.
- 300 → 3,400 Hz is the classic telephone voice band, useful when checking intercoms, radios and small speakers made for speech.
Listening for the right things
A healthy sweep sounds like one clean, rising whistle. Listen for anything that is not part of it: a buzz, a flutter, a second pitch riding along, or a sudden jump in loudness. Buzzes that appear at one frequency and vanish a moment later are mechanical — something is loose and resonating. A second, higher pitch in the deep bass is usually distortion: the speaker is being asked for more than it can do.
Volume and safety
Set the level with the sweep stopped, start low, and leave it. Your ears are least sensitive at the two ends of the range, which tempts you to turn it up — and then the middle of the next sweep is far too loud. Deep sweeps at high volume can also damage small speakers, so keep bass sweeps short and stop at the first knocking sound.
Guides
Questions
Should I use a logarithmic or a linear sweep?
Logarithmic for listening. We hear pitch on a log scale, so a log sweep spends the same time on each octave — 20 to 40 Hz takes as long as 10 to 20 kHz. A linear sweep moves the same number of hertz every second, so a 20 Hz–20 kHz linear sweep races through the bass in a fraction of a second and spends most of its time in the treble. Linear is for measurement procedures that ask for it.
How long should a sweep take?
For hunting rattles and buzzes, slow: 20–30 seconds for the full range, so a resonance has time to build up and be heard. For a quick check of where a speaker's range ends, 10–15 seconds is fine. For testing your hearing at the top end, go slower still — 30 seconds or more across 8–20 kHz.
What is a sweep used for?
Finding where a speaker, headphone or room stops, peaks or rattles. A loose panel, a damaged driver or a room resonance shows up as a buzz or a sudden jump in loudness at one point of the sweep, which a single tone would only find by luck. Sweeps are also how acoustic measurement software captures a frequency response.
Why does the sweep sound uneven in loudness?
Partly your equipment, partly your ears. No speaker is flat, and rooms add peaks and dips in the bass. On top of that, human hearing is far more sensitive around 2–5 kHz than at either end, so even a perfectly flat system sounds loudest in the middle of the sweep.